Pour the component B in the component A. The two components are already prebatched in the correct ratio to be followed also when only one part of the original package is to be used.

Carefully mix the two components preferably by a mechanical mixer with slow speed till getting a homogeneous colour.

ADEPOXY MATERIA or ADEPOXY MATERIA TECH is easily applied in the joints with stiff rubber or steel squeegee, completely filling the joint volume. Remove the excess by a stiff rubber squeegee used diagonally on the joints.

Cleaning must be made with the product "still wet" within 30 minutes from the application, with a sponge dampened with water, rubbing till residues are completely removed and caring not to empty the joints (replace the sponge when it is too much impregnated with resin).

The part emulsified in water can be collected with a rubber rake, paying attention not to wet the joints still to be filled. Final cleaning is made with water and alcohol when hardening starts and before it is completed. Hardening starts after about 40 minutes and after 24 hours the surface is ready for traffic. A good resistance to chemicals is already achieved after 3 - 4 days.